Drywalling: 9 Tips for Professional Results

Would you like to learn the drywall taping tricks and techniques that professional drywall contractors oklahoma city use to speed up their work and perform drywall repair perfectly?

 

You too can also avoid annoying issues like lumpy mud, tape bubbles, nail pops and get a more flawless finish every time.

But do be warned – even if you follow all tips to the letter, you might not get the type of professional results you expected, as drywalling requires hand-eye coordination. You also need to develop the necessary know-how that entails drywalling, like the flexibility of tools and consistency of the joint compound.

 

 

  1. Drywall Must be Ready

Flawless drywall repair okc results begin with top-notch hanging jobs. You need to make sure that the drywall is tight against the wall studs or your ceiling joints. Screws should not be able to tear paper, so make them countersunk. Add more fasteners and tighten your tapered seams. Give a gap of a quarter inch on all corner and other joints.

 

 

  1. Mixing Mud Perfectly

Do not use premixed mud from a bucket or a box as that is usually too thick and hard. Instead, you can add some water and whip it up to a creamy frosting consistency. Take care to avoid lumps. And do not whip it too much as that will incorporate air in it. More air means more air bubbles as you’d apply and finish the mud process.

 

 

  1. Paper or Mesh Tape – Pick One or Both

You can utilise both in one go. For tapered seams, use a self-adhesive tape and for corners, use paper tape. You can just use a paper tape for the entire drywalling operation, if you’re comfortable with it.

drywall repair

 

  1. Utilising The Right Tools for Taping & Finishing

  Use a 5-inch wide steel blade for taping and 10-12 inch stainless steel knives for finishing. It is critical that you utilise a file to round off all corners of your taping knife, just a tad, because a new knife has razor-sharp corners that might tear the paper tape right when you’re gliding down a corner seam.

 

 

  1. Finishing Order Smoothly

  Finish all flat seams in the beginning and then run tape to within 1 1/2 inch of the corners. Do all inside corners at the very end of the dry walling process so that this tape then overlaps the flat seam tape. Nail all metal and curved corner beads properly before taping.

 

 

  1. Size of Your Work Area is Relevsnt When You’re Taping

  In the wall corners and on all the flat seams, apply mud to approximately 4-5 linear feet of seam. Then press the tape in place and scrape off excess mud from the seam. But do stop at about 6 inches of mud from the end, and apply more to your drywall to proceed further.

 

 

 

  1. Begin the Second Coat Instantly After Taping

  Once you finish the whole taping process, begin the second coat immediately. You do not need to wait for the tape to dry out first, as it will automatically dry up as your second coat dries.

 

 

 

  1. Second Coating All Corners Perfectly

Do not apply a second coat of the creamy mud on both sides of a corner simultaneously. Do one side today and come back for a second coat, in a day or two, when the mud dries off. Finish the 3 corner surfaces where a ceiling interacts with the inside corners of two walls at one point. There should be a one by sixteenth inch layer of mud over the tape once the whole process is completed.

 

 

  1. Apply a Sealer or Primer after the Third Coat of Mud

After the third coat of mud is applied nicely, and final sanding of the seams is done, along with corners and nails, you really must apply a top quality sealer or primer to your walls before painting to save all your hard work and make your end results look spectacular. click here to cotact